Galaxy Dimension 96 - Two Bell Boxes Wiring Clarification

Hi All,

I have a Galaxy Dimension 96 installed and set up which is fully operational apart from the external bell boxes.

The two bell boxes are both Pyronix, Different models hence only one has the ability to disable the back light.

I am able to wire them to either the main panel or to a closer RIO. (Which i would prefer to do)
I have put together the schematic below showing how i think it would be wired.

I would be grateful if those with more experience than me could check it over?
p.s. do you feel i need to set the front bellbox as SCB as opposed to SAB?

Thanks in advance

 

If it was me ....wire one bellbox to the panel and the other to the rio ...separate tamper indications and less load on one output ...

 

a most excellent suggestion sparkymarka

 

Thanks for the suggestion.
A lot easier and allows identification of the bell box if any future fault occurs

 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Please select a service and enter a location to continue...

Plumber / Gas Engineer Electrician Builder Decorator Builders' Merchant Plumbers' Merchant Tile Supplier Flooring Supplier
Start Search

Are you a trade or supplier? You can create your listing free at DIYnot Local