error

Hi, I have seen some good articles on here so hopefully you can help me. I have just wired a new PIR to my Texecom Premier Elite 24 panel. The PIR I am wiring is a 'Premier Elite MR'. I copied the same wiring as my existing three PIRs but I am getting a Tamper error. I have seen some...

Hi We have an old Honeywell system. They keypad has a sticker on it saying Grade 3 Class II. There had been some low battery errors for a while so as the walls were being painted the opportunity was taken to replace the batteries in the sensors mentioned on the keypad. No alarm went of when...

Hi all, Been trying to upload some pictures of my latest project, and I'm getting the following error: The following error occurred Security error occurred. Please press back, refresh the page, and try again I'm uploading from a local disk drive, using chrome, etc.. Anyone got any ideas what...

I have a Vitodens 100 WB1A boiler and just lately we've been getting an error where we don't get hot water after using it for washing up for example. We have to press reset for it to work again, however it keeps occurring. We've researched it and it came out as too low pressure and you need to...

Just went to check back on my latest thread about the Di-Log DL9118 MFT, and to my surprise all links in the thread now says: "This link is not visible to you." Worse still, all links on all posts site wide for me now say this as well and no longer work. This is what I now get on such a...

Hi everybody, We have a washing machine INDESIT (perhaps with another brand in other countries), model XW A 71252 W EU. During 30 months it has gone right, but two monts ago, after 30 minutes running on whatever washing program, it stops with all LEDs flashing. We did a complete reset. Then...

Hi all. Trying to find what this fault code on my T294C Dryer means: It starts up but does not heat up. Have had previous faults of starting up with heat but then shutting down after a few minutes with beeps. I have trued a new Miele NCT (temp sensor) which made no difference. Wiping the...

Hi, looking for some expert advice please as tearing my hair out... My Scantronic 9651 alarm will not arm because of an error on one of my PIR zones (the alarm went off last week). The panel shows the yellow triangle light. When I enter the user code and try to arm, I get the red spanner as...

hi everyone I have a Hoover 8Kg DYN8144DIX washing machine that takes water in (the right amount), heats it, washes throughout normal cycle, drains dirty water as expected, but very rarely gets to the spin. in the very end of the cycle, just before it would start the spin, it shows error E:03...

Does anyone have any experience of this? Had this last week and remove some of the parts at the bottom and the filter and it "seemed" to work again for a while.. Last night, it came on again with E:15 error and some of the water leaked out of the front? This is obviously a draining issue.. as...

Put the washing machine on last night, but after pressing the start button, it just sits there, then after a wait, the display says "door". The door is latched and locked, but that's all that happens. Please help advise what to check.

Hi, I have a Glow-Worm Flexicom 30 cx installed in a ground floor flat. A couple of weeks ago it started reading error messages F4 and F13. The Glow-Worm man who came round opened it up to find some water inside the boiler and said that we had to call the installation man as it looked like an...