3/4" BSP thread to 15mm pipe

[GaryMo]

What's the best way to get from a 3/4" BSP tap tail (~26mm OD) to a 15mm copper pipe?

EDIT - I've found some adaptors and also flexible pipes so a couple of options.

 

[keego]

Try this
http://www.screwfix.com/prods/81835...tings/Conex-Straight-Tap-Connector-303-15mm-x[/url]

 

[Mymonkeylovin]

Thats expensive!

Try here:

http://www.ukhps.co.uk/straight-tap-connector-1146-0.html

 

[keego]

I said try THIS, not buy THIS HERE!

 

[Nige F]

End feed fittings are cheaper than compression

 

[Goldspoon]

Thats expensive!

Try here:

http://www.ukhps.co.uk/straight-tap-connector-1146-0.html[/QUOTE]

That's also not what the OP asked for :-;

 

[Garfeild]

Thats expensive!

Try here:

http://www.ukhps.co.uk/straight-tap-connector-1146-0.html[/QUOTE]

Thats the wrong way round.

 

[Paul Barker]

I said try THIS, not buy THIS HERE!

And it's the correct part

 

[Nige F]

but end feed is still cheaper

 

[GaryMo]

I opted for 500mm long flexible hoses with a 3/4" BSP threaded fitting on one side and a 15mm compression fitting on the other side. Cost was £5.86ea from B&Q.

Thanks everyone.