I need to rotate my standpipe in the utility through 90° due to moving my washing machine. However, the I have an elbow which is solvent welded and only an inch or so above the floor.
I am worried that once i cut the joint off, I wont have enough to get a good joint onto.
Is there an internal fitting (or other sized pipe?) that I can insert down inside the pipe so that I can extend it upwards?
I am worried that once i cut the joint off, I wont have enough to get a good joint onto.
Is there an internal fitting (or other sized pipe?) that I can insert down inside the pipe so that I can extend it upwards?