Hello,
I want to add another radiator to the CH circuit, i intend to do this by inserting two tee joints into the send and return circuit that runs round the house. My question is if i cut the correct amount of pipe out to fit a tee how do i actually get the tee in? as there is no play in the pipes and if i cut them wide enought to fit the tee, then there is not enough pipe to feed in? Is there a specail technique i need to be aware of?
I hope that make sense.
I want to add another radiator to the CH circuit, i intend to do this by inserting two tee joints into the send and return circuit that runs round the house. My question is if i cut the correct amount of pipe out to fit a tee how do i actually get the tee in? as there is no play in the pipes and if i cut them wide enought to fit the tee, then there is not enough pipe to feed in? Is there a specail technique i need to be aware of?
I hope that make sense.
