- Joined
- 24 Nov 2006
- Messages
- 2
- Reaction score
- 0
- Country
I am replacing my fluorescent lights with low bay lights x10 I am planning to run a new circuit from the blocks in my 3 phase supply ( right side of meter) to enable my lights to go through an upgraded system as my consumer unit is rather old. I was wondering what size mcb i require and is this a feasible way to do the job.I plan to use 2.5 twin and earth and put them on one circuit with a three way switch at the door.through junction boxes any probs with this I appreciate your advice
cheers
cheers