Alarm PIR wiring

[Birdy Mel]

Hi, apologies if this has been addressed before. I have a Honeywell IS312B PIR that I am attempting to wire into a accenta mini Gen4 panel. For the sensor, I have used the following,
T2-blue
T1-white
NC-yellow
C-green
V- black
V+. red.
Please advise where these should connect up in the control panel.
There will only be one PIR used and no other switches used, so will I have to link any others out?
Much appreciated.

 

[Matt W]

Hi
Wire blue and white into the TAMP terminals (doesn't matter which way round).
Wire green and yellow into Zone 1 (doesn't matter which way around)
Wire red to +13v and black to 0v.

You can either link out the other zones or disable them via the engineering mode.

Matt

 

[Birdy Mel]

Many thanks Matt, much appreciated, cheers