Hello all i am having trouble installing my alarm, i have a ADE Accenta Mini Gen4 & 4 with 4 bosch pir’s, I want 4 zones one pir for each zone
The question I have is do I wire the contact & tamper in series & the + & -in parallel? If so how is this possible with one wire (6 core)
I have wired the pir's as follows, but the alarm will not set
pir +...........................control panel + (red)
pir-.............................control panel - (black)
pir nc.........................control panel zone 1 (blue)
pir nc.........................control panel zone 1 (yellow)
pir t...........................control panel t (green)
pir t...........................control panel t (white)
The tamper on the control panel is bridged with a u wire....
Connector DC on the pir is not wired
Appreciate some help i am pulling my hair out!
Thanks the advice!
The question I have is do I wire the contact & tamper in series & the + & -in parallel? If so how is this possible with one wire (6 core)
I have wired the pir's as follows, but the alarm will not set
pir +...........................control panel + (red)
pir-.............................control panel - (black)
pir nc.........................control panel zone 1 (blue)
pir nc.........................control panel zone 1 (yellow)
pir t...........................control panel t (green)
pir t...........................control panel t (white)
The tamper on the control panel is bridged with a u wire....
Connector DC on the pir is not wired
Appreciate some help i am pulling my hair out!
Thanks the advice!