I have done that and it heats.
When u turn all on again it stops heating
When u turn all on again it stops heating
Balancing Rads
- Thread starter NewhouseOldhouse
- Start date
Sponsored Links
- Joined
- 8 May 2017
- Messages
- 9,422
- Reaction score
- 2,344
- Country
You have established that the rad that didn't heat up ,will do if it gets its share of the flow. So it looks like your system just needs balancing.
If you now open TRV's ,and close all lockshields ( leave the rad that's heating up in its current state) and take each new rad in turn and open it's lockshield very slightly ,until it heats up. Then move onto the next rad.
If you now open TRV's ,and close all lockshields ( leave the rad that's heating up in its current state) and take each new rad in turn and open it's lockshield very slightly ,until it heats up. Then move onto the next rad.
Brilliant terryplumb.
Should I have the rad that didn't heat up temp set as in return 12 degrees cooler than flow before I start to set other rads?
Should I have the rad that didn't heat up temp set as in return 12 degrees cooler than flow before I start to set other rads?
- Joined
- 8 May 2017
- Messages
- 9,422
- Reaction score
- 2,344
- Country
I wouldn't worry too much at this stage,until you get all rads heating up.
Sponsored Links
Doing this now heating has been on about 15 mins rad not heating is very hot - do I work back on myself now ?
- Joined
- 8 May 2017
- Messages
- 9,422
- Reaction score
- 2,344
- Country
Yes ,move onto next rad
Right have all rads back on and now 2 of the rads on the new pipe work had cooled down as in return pipe went cold any ideas?
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
