Bargain door?

[neholgate]

I went to a local DIY store to look for a new exterior door. They have section of "bargain" returned doors.
I found one the right size and style I needed (originally $315, now $130).
Problem? The Bottom threshold on one end is detached, doesn't appear broken, but obviously will have to be fixed. This is a steel door.

The question: How easy is it to fix? Should I get an expert? Would the price of fixing the door negate the bargain price (costly repair?).

Thank You.

 

[JohnD]

can you post a photo?

To me, the word "threshold" describes that part which is part of the frame, and goes on the floor, under the door. I might also call it a sill.

You did not mention that you had bought a frame so I can't visualise what you mean.

 

[neholgate]

can you post a photo?

Unfortunately, no. I have not purchased the door yet.

To me, the word "threshold" describes that part which is part of the frame, and goes on the floor, under the door. I might also call it a sill.

That is correct. The part that has come detached is at the junction of the vertical piece and the sill or threshhold. I didn't see any spiliting of the frame at all, just looks like it just became detached, for some reason. Looks like they (probably the installers at the DIY store) tried to repair it using a staple gun, but gave up.

You did not mention that you had bought a frame so I can't visualise what you mean.

The whole door is supposed to come pre-hung, with the frame. It is the frame part at the one side of the threshold that became detached.

Because it's a steel door, I was wondering if the repair is fesable, or even worth it (meaning cost of someone to repair anf hang would be too much).

Here's the door from the store ad:
http://tinyurl.com/2lg5p9

Thank You.

 

[JohnD]

can't see it.

Lowes want to know my ziiiiiip code

If you can copy the properties of a picture of the door set (filename ending in .jpg) i may be abe to see it. If you have to pay someone else to repair it, it will probably be cheaper to just buy an undamaged door at full price.

If the frame is fastened to the walls at 3 or more points on each side, properly square, then the threshold shouldn't be under any stress in use. I would have thought it could be reattached with glue and screws (if wooden) or stainless self-tapping screws and epoxy resin (if steel).

Wooden frames usually have a hardwood sill which is attached by tenons on the stiles or sides of the frame. the sill is not screwed down to the floor but may fit in a pocket or step which prevents it moving.

repairs to a wooden sill have to centre on protecting it from water ingress which will cause rot.

Internal doorsets are supplied without a threshold as it is not needed