Hi,
Hopefully this is an easy one for people on here.
We have a bath/shower and the door has started to let water through. I'll post some pictues of what's there now. It's basically 2 white rubber (?) strips glued one on each side by the people that had the house before us. These have got into a state over time and bits are now dropping off!
I've seen different variations on these...
etc
...but because the door centres right in the middle of the edge of the bath and there's not much of a gap most of the length, I'm not sure these will do it.
This image shows how they had to glue it on not straight to close the gap (btw, I am about to renew the sealant on the corner part - that is also letting water through)...
My question really is what to use, where to get it and what to use to glue it on with?
Thanks!
Hopefully this is an easy one for people on here.
We have a bath/shower and the door has started to let water through. I'll post some pictues of what's there now. It's basically 2 white rubber (?) strips glued one on each side by the people that had the house before us. These have got into a state over time and bits are now dropping off!
I've seen different variations on these...
etc
...but because the door centres right in the middle of the edge of the bath and there's not much of a gap most of the length, I'm not sure these will do it.
This image shows how they had to glue it on not straight to close the gap (btw, I am about to renew the sealant on the corner part - that is also letting water through)...
My question really is what to use, where to get it and what to use to glue it on with?
Thanks!
