Baxi 105e, 30 & 40 flashing after new pcb install

[james4204]

Hi there
i was having problems with my boiler, the fan light (50) was flashing, after reading through posts on here, i decided to buy a new pcb.

i have conected ( i think ) everything up coprrectly, but now when i turn it on the 30 & 40 degrees lights flash, and nothing else happens, any suggestions? do i need to do anything else with the board before installing?

on the new board 5112380 the lay out is different, but is pretty idiot proof as to were the connectors go, and there is an extra earthing wire that i connected to the eath strip witht he other earth leads, i assume this is correct?

please help as im freezing and smelly lol

 

[james4204]

this is replacing the old type pcb

 

[mgheating]

i suspect it would have been cheaper to call in an rgi

 

[jackthom]

Have a read of this thread.

//www.diynot.com/forums/viewtopic.php?p=535578#535578

 

[james4204]

Have a read of this thread.

//www.diynot.com/forums/viewtopic.php?p=535578#535578

i tried searching, but obviously looked for the wrong thing!

and this thread sorted the problem, thanks for the advice

 

[baxpoti]

Hold reset for 10 seconds