So I've just had British Gas around and the damn bolier didn't fault whilst they were here but did when they left. Typical. Here's my problem. On either central heating or hot water mode I get the flashing radiator fault, central heating sensor. This cut in normally in the middle of a shower, which is nice. The Gas man said this was a pressure issue, and i had a bit of a leak, so I took of the offending fitting, smothered it in PTFE and carried on. I then had a hot shower, that worked OK, without faulting. Now after the shower the boiler is stuck in hot water mode. I don't have the pre heat on, but the hot water light is on and the pump is running. The heating is on and i've turned the thermostat up to 30 to ensure demand, but the boiler is just sat on hot water. Any ideas?
Baxi Instant Combi 105e problems
- Thread starter Frenzies
- Start date
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Similar threads
