Hi there,
Have done the male/female mitre'd cuts on the new laminate worktops for the kitchen and have cut both the bolt (x3) and biscuit recesses (x6) in each ready for assembly.
However, having never done this before, so I thought I'd get some "expertise" from the field.
Given that I will probably have to glue and assemble and colourfil the joint(s) in one go (I think) ... what do you guys suggest is the best way to do this without too much hassle... as I heard that the colourfill can set quite quickly, so I don't want to **** it all up after I've spent so much time in the preparation already.
All comments, thoughts and suggestions gladly appreciated.
Joe
Have done the male/female mitre'd cuts on the new laminate worktops for the kitchen and have cut both the bolt (x3) and biscuit recesses (x6) in each ready for assembly.
However, having never done this before, so I thought I'd get some "expertise" from the field.
Given that I will probably have to glue and assemble and colourfil the joint(s) in one go (I think) ... what do you guys suggest is the best way to do this without too much hassle... as I heard that the colourfill can set quite quickly, so I don't want to **** it all up after I've spent so much time in the preparation already.
All comments, thoughts and suggestions gladly appreciated.
Joe