Howdy,
The subject line says it all. I need to strip clean 100 metal doors for my business. I've researched a bit and there seems to be varying consensus on pressure washers, etc.
So what's the quickest, most cost effective way to accomplish this task? What are some of the risks? I've read that striping is an issue if a pressure washer is used improperly.
As a side note:
I've been trying to find information on something I saw on TV once. A UK inventor (if I remember correctly) designed a pressure paint remover that was just incredible to watch. This was a few years ago, but it used no/little water and just some sand. He stripped a wood table of paint in about five minutes vs. the comparison subject who took several hours using a flame and spatula. They said this product was going to be commercialized but I haven't found anything about it at all. Any ideas?
Thank you
Mack
The subject line says it all. I need to strip clean 100 metal doors for my business. I've researched a bit and there seems to be varying consensus on pressure washers, etc.
So what's the quickest, most cost effective way to accomplish this task? What are some of the risks? I've read that striping is an issue if a pressure washer is used improperly.
As a side note:
I've been trying to find information on something I saw on TV once. A UK inventor (if I remember correctly) designed a pressure paint remover that was just incredible to watch. This was a few years ago, but it used no/little water and just some sand. He stripped a wood table of paint in about five minutes vs. the comparison subject who took several hours using a flame and spatula. They said this product was going to be commercialized but I haven't found anything about it at all. Any ideas?
Thank you
Mack