I have a Biasi M90E 24S, the hot water is not working as boiler does not fire up when tap turned on. If I turn on the heating and let the boiler fire up then turn on the water it will flow hot. But if I turn on the tap and let the water flow cold then switch the heating on the boiler will not fire up until tap is turned off. Someone said it may be a flow switch sensor or something?
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Biasi M90E 24S hot water problem
- Thread starter Paulgreen700
- Start date
yes it could well be 
or the diaphram in the dhw flow switch
or a sticky diverter
or the diaphram in the dhw flow switch
or a sticky diverter
If the boiler makes a little noise when just a tap is turned on but does not fire up then the fault is likely to be the pump proving switch is not being ativated by the operating pin.
Unlikely to be the Hall effect sensor in this case.
Tony
Unlikely to be the Hall effect sensor in this case.
Tony
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
