I'm knocking down a wall and removing the radiator completely so need to cut the pipework down so it's under the floor and blank off.
It's 10mm plastic, are pushfit blanking ends the best way to blank off and should I use pipe inserts prior to fitting the blank cap or would a compression fitting be best (not sure if this would be wise to use on plastic?)
If so any particular brand of pushfit recommended?
It's 10mm plastic, are pushfit blanking ends the best way to blank off and should I use pipe inserts prior to fitting the blank cap or would a compression fitting be best (not sure if this would be wise to use on plastic?)
If so any particular brand of pushfit recommended?