Cement screed

[beatts]

Hi


At the end of my drive where the tarmac footpath meets the block paving is some sort of cement / concrete bridging section (0.3m wide x 0.5m long)

It has been cracked (when a jewson delivery van put his outrigger on it without a board! good of them!)

anyway upon inspection it looks like it is not concrete because I cant see any gravel / ballast in it. I think it is a sharp sand / cement mix

Rather than removing all of the cement I just want to patch up the broken part.

Therefore what would be a suitable mix ratio for sharp sand / cement.

I forgot to mention it is about 2 inches deep.

thanks in advance for your help

 

[noseall]

3:1

three sharp sand to one cement. don't overdo it on the water.