Hi All. I’ve searched the forum to see if the question I am about to ask has been raised before by anyone else. I find that it has, but it didn’t get any replies!! I’m not sure if that’s because it’s such a dumb question, but here goes……… I am renovating a bathroom, and having removed old ceramic tiles from the ‘basin’ wall’ (ie no shower or bath against it) most of the plaster has come away, leaving the old sand/cement render visible. This was mainly due to the amount of adhesive previously used…there is no signs of damp. Question is, can I seal the render with pva or similar, and then tile directly onto it? I would like to avoid having the render plastered because of the time delay in the plaster fully drying out.
Any comments/advise would be much appreciated.
Any comments/advise would be much appreciated.