Hello to everyone. Got the above wireless alarm system in the car boot today. There is an antenna that can be attached to it but when you open the control panel the wires have been cut and there is a round space were something seems to be missing, if there is a way of uploading a picture I could show you. Incidentally the control panel says AD 2020 and Omnicron 6000. At a guess I'm thinking the missing part is a receiver? The box has three PIR's in it, a remote and a smoke detector. About one third of the box on the left is a space that looks like it should take more than the manual and guarantee. All help appreciated very much.[/img] just uploaded the pictures.
Challenger AD 2000
- Thread starter jaimzward
- Start date
digging up some old stuff then, doubt you be able to get any parts for it other than off ebay or if anyone has some tucked away in the garage.
looking forward to the pics.
looking forward to the pics.
Bin it , they where rubbish 20 years ago ! This wasn't a radio panel to start with ! looks like a mod done by third party
It was only a fiver just got it to mess about with.
So there is something missing from inside the panel?
Probably the receiver ! I have taken out a omnicrom wireless panel in the last few months and the receiver was built in , at least you can use it as a hardwired panel .... If you must .....
Thanks, I'll use it on my shed, a few have been broke into around here this past month.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local