That's possibly where I slipped up - didn't clean inside as it was a new elbow but I did apply flux internally. I think the joints are good (gave them a good old tap to test!) but do you think I am taking too much of a risk leaving it as it is?
Combi system losing pressure
- Thread starter craig1234
- Start date
Sponsored Links
Then dont do that next time flux ONLY goes on the pipe never inside any fitting, putting flux inside a fitting , when the pipe is inserted it will push the flux into the waterway
I can hear the groans when I say that the reason I added flux into the fitting was because I followed the advice that I had seen on YouTube!! Anyway, point taken and I won't be doing that again - this is one of my efforts from today - am getting better I think.
Sponsored Links
- Joined
- 8 May 2017
- Messages
- 9,414
- Reaction score
- 2,342
- Country
Looks more like a well soldered joint.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
