Composite door help

[Hamza]

Hi all.

I’m new to this forum and was hoping to get some advice with a new composite door I fitted.

the door seems to be catching the frame at the bottom corner. I have watched videos online on how to adjust the frame but the hinges don’t seem to have any Allen key points.

I have attached a couple of photos for reference.

Any help with me greatly appreciated!

thank you.

 

[Deleted member 267285]

The Allen key points (which are easy to see on your photo’s) are in the middle of the hinge. Whether they’re adjusting points though I don’t know.

 

[Hamza]

Thanks for the message. I’ve tried those points, they don’t adjust the door unfortunately.

 

[ronniecabers]

Using the picture with four screws visible ... firstly mark where they are now ( a reset point if all goes wrong ). You should need to adjust top and bottom hinge . Undo and remove screws 1 and 3 ( counting from top ) . Loosen but DO NOT remove 2 and 4 , the door can physically be moved whilst 2 and 4 are loose . Retighten 2 and 4 and check it is closing correctly , readjust if needed , refit 1 and 3 . Personally I think these types of hinges are rather stupid!