- Joined
- 26 Jul 2015
- Messages
- 316
- Reaction score
- 8
- Country
I have a crosswater crossbox to install for a shower.
Wall is Thermalite breeze and plan to channel out for the valve and pipes as I have limited space.
Its an unvented system and I have two previous Polypipe tails from a Bar Mixer that was dropped down the ceiling available to connect in with full bore isolators but I would like to do Copper to be sure this install is solid and I never see it ever again (getting wet).
Crossbow terminates at the bottom of the valve so I need to go down then up to feed in. The Shower head will be a run out and then Hand mixer right next to the valve.
I have bought a pipe bender....
Is this going to be suitable to do with bends and be suitable pressures or am I being naive?
Wall is Thermalite breeze and plan to channel out for the valve and pipes as I have limited space.
Its an unvented system and I have two previous Polypipe tails from a Bar Mixer that was dropped down the ceiling available to connect in with full bore isolators but I would like to do Copper to be sure this install is solid and I never see it ever again (getting wet).
Crossbow terminates at the bottom of the valve so I need to go down then up to feed in. The Shower head will be a run out and then Hand mixer right next to the valve.
I have bought a pipe bender....
Is this going to be suitable to do with bends and be suitable pressures or am I being naive?
