Connecting Shower Mixer Using JG Speedfit

[WSB]

I have a "Grohe 33555002 Eurosmart New AP Single-Lever Mixer" and am looking at ways to connect to my water supplies.

Have used JG Speedfit in the past with small projects and would like to do again.

Rather than use compression fit or soldered pipes, I would like to connect from my 15mm copper piping to the mixer with JG Speedfit parts.

Could you please advise on what connectors I'd need.

Many Thanks!

 

[dilalio]

https://www.google.com/search?q=spe...bile&ie=UTF-8#scso=_Gs8-YtWlEOWy8gLGwLqYBQ3:0

Depending on the tappings on your valve, you will need either 1/2" or 3/4" bsp adaptors. I didn't search more for a 3/4" to 15mm so don't know if they're available. If not, you'll need to use bushes.

 

[WSB]

Mant thanks,
how do i measure to check whether 1/2" or 3/4" bsp?

 

[Madrab]

Mant thanks,
how do i measure to check whether 1/2" or 3/4" bsp?

Should be in the manual - look for a measurement for the inlet pipe, should read G1/2" or G3/4"

JG do both 15mm>1/2" and 15mm>3/4" tap connectors