I'd like to add extra sockets to the house I've just bought, which means at some point I'll need to perform a continuity test to determine whether specific sockets are on the ring circuit.
All the information I've seen on performing a continuity test indicates that all appliances need to be unplugged from the ring circuit and all sockets turned off.
The problem that I've got is that there's a socket upstairs that isn't easily accessible, because there's a very large/heavy wardrobe in front of it that's been screwed to the wall! The socket has only got an extension cable plugged into it, but no appliances. I'm pretty sure it's switched on as well, otherwise the extension would be a waste of time!
Is this going to cause me problems when performing a continuity test on another socket in the same room?
Just out of interest, what we happen if a continuity test was performed with an appliance plugged in?
Any advice would be much appreciated. Thanks.
All the information I've seen on performing a continuity test indicates that all appliances need to be unplugged from the ring circuit and all sockets turned off.
The problem that I've got is that there's a socket upstairs that isn't easily accessible, because there's a very large/heavy wardrobe in front of it that's been screwed to the wall! The socket has only got an extension cable plugged into it, but no appliances. I'm pretty sure it's switched on as well, otherwise the extension would be a waste of time!
Is this going to cause me problems when performing a continuity test on another socket in the same room?
Just out of interest, what we happen if a continuity test was performed with an appliance plugged in?
Any advice would be much appreciated. Thanks.