Hi,
As there was some dirt under the control knobs, I pulled them out and tried putting them back. I noticed that on two of them the metal piece that stands (this metal bit goes into the back of the knob) dropped down by a couple centimetres making the length of it smaller. As a result of it, the plastic knob doesn't fit in properly and when it's turned on to a heat setting, it trips RCD.
I tried inserting a small plastic piece under the knob so that the knob stays up and this time I had no issues. I have this issue on just two out of 4 knobs.
What could have gone wrong or how can I get this fixed?
Thanks
As there was some dirt under the control knobs, I pulled them out and tried putting them back. I noticed that on two of them the metal piece that stands (this metal bit goes into the back of the knob) dropped down by a couple centimetres making the length of it smaller. As a result of it, the plastic knob doesn't fit in properly and when it's turned on to a heat setting, it trips RCD.
I tried inserting a small plastic piece under the knob so that the knob stays up and this time I had no issues. I have this issue on just two out of 4 knobs.
What could have gone wrong or how can I get this fixed?
Thanks