is there a bit that would sink wood and mild steel for eg opening up hinge countersinks seen hss and titanium any advise please
countersink bits advice
- Thread starter norbellini
- Start date
M
merlin50
i always use dormer hss last longer than any other
These are spot on, cuts steel no probs and keeps it's edge, also flys through timber.
http://www.screwfix.com/p/ruko-countersink-8mm-12-4-x-56mm/87508
http://www.screwfix.com/p/ruko-countersink-8mm-12-4-x-56mm/87508
Would these not be better MrTinker?
http://www.screwfix.com/p/ruko-slotted-deburring-cutter-8mm-5-10mm/64084
I only use them on wood and thus have little experience with metals
http://www.screwfix.com/p/ruko-slotted-deburring-cutter-8mm-5-10mm/64084
I only use them on wood and thus have little experience with metals
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
