Hi,
We have a project ongoing at the moment and we basically have a laminated worktop (like a kitchen worktop) and want to sink a computer keyboard into it so that the keyboard is flush with the worktop (its a work thing).
Whats the best way of making a recess (i.e removing a 15mm deep rectangle of materiel about 300mm x150mm) in the worktop without cutting right through. the plan is to use a router but we are worried about it chipping the laminate.
if using a router is a sensible way to go about it, what sort of bit should i buy?
Sorry if this has been covered before....
Cheers
Andrew
We have a project ongoing at the moment and we basically have a laminated worktop (like a kitchen worktop) and want to sink a computer keyboard into it so that the keyboard is flush with the worktop (its a work thing).
Whats the best way of making a recess (i.e removing a 15mm deep rectangle of materiel about 300mm x150mm) in the worktop without cutting right through. the plan is to use a router but we are worried about it chipping the laminate.
if using a router is a sensible way to go about it, what sort of bit should i buy?
Sorry if this has been covered before....
Cheers
Andrew