Good morning everyone,
We have a Valiant ecoTEC plus boiler with a Drayton digistat +RF thermostat and digistat scr receiver installed.
All seemed to be going well until the area had a power cut last week and now the heating won't go above 20 Celsius.
I have set the thermostat to 22 degrees. The green light on the SCR stays on permanently but the boiler doesn't seem to kick the heating any higher. The valiant is on (rather than on timer at the moment) and it is going though the 'Anti cycling mode' constantly, and the thermostat is permanently saying that it is transmitting ... But the heat won't go higher than 20 degrees.
I have recommissioned the Drayton + RF and the digistat SCR, and they seem to be communicating fine, so has anyone got any ideas why the temperature won't get any higher?
We have a Valiant ecoTEC plus boiler with a Drayton digistat +RF thermostat and digistat scr receiver installed.
All seemed to be going well until the area had a power cut last week and now the heating won't go above 20 Celsius.
I have set the thermostat to 22 degrees. The green light on the SCR stays on permanently but the boiler doesn't seem to kick the heating any higher. The valiant is on (rather than on timer at the moment) and it is going though the 'Anti cycling mode' constantly, and the thermostat is permanently saying that it is transmitting ... But the heat won't go higher than 20 degrees.
I have recommissioned the Drayton + RF and the digistat SCR, and they seem to be communicating fine, so has anyone got any ideas why the temperature won't get any higher?