drayton rf3 wireless control

[teddyb]

Hi there
We have drayton wireless control for our central heating, which was working really well .... until a plumber was working, needed the power off and then pressed some buttons on the SCR. I suspect he shouldn't have done! The rf3 is not not sending, or the SCR is not receiving anymore so we are having to manually override in order to get the heating.

We have the instructions for commissioning the system, is that what we should do? We also have the set up instructions. What we don't have is a troubleshooting section, for when things, like this, happen.

Can anyone please advise how to remedy this?
As always, I shall be really grateful for your advice.
Thanks,

 

[doitall]

Has the plumber fitted a pipe or anything close to the SCR that will effect the signal.

Warning: Installing the SCR too close to the metal side
panel or mains cables may interfere with the radio signal.



1. Turn off the power supply to the Digistat SCR (receiver unit)
and leave for 5 seconds.
2. Turn on power to SCR unit and check red light is on.
3. Press override button No.2 and check the green light comes
on and boiler fires.
4. Press & hold down button No.1 (Keep depressed), then
press No.2 and keep depressed. {The Red LED light will flash
a couple of times and then it will go out}
5. Now release both the buttons – {the two LED lights should
come back on}
6. Get the Digistat+2RF/+3RF unit and stand two metres away
from the SCR unit with the Digistat+2RF/+3RF unit in your hand.
7. Remove the battery cover and fit the batteries.
8. The Red LED light on the SCR will now flash for approx. 7
seconds.
9. This confirms that the radio signal is being sent and
received.
10. The Digistat+2RF/+3RF and the SCR are now successfully
linked by a dedicated RF address.
11. Install the Digistat+2RF/+3RF as follows:

 

[teddyb]

Hi doitall

Thanks for your response ....
No there was no new pipework at all.


I don't know why, but point 11 was the last I could see and it ended install as follows: (?)

Was anything else coming .... ?

I appreciate your help!

 

[doitall]

It was installed before so you shouldn't need anything past point 11.

If you want the whole Doc email me an address to send it

in my profile

 

[teddyb]

OK. I'll have a go tomorrow. It's too late now to try. I'll let you know how it goes.

Thanks

 

[teddyb]

Thanks doitall!

Everything is now working fine.

I am very grateful to you!