I was tempted to post this in DIY Disasters but hoping for some help here first.
I have kitchen units from Wren (yes i know...) two wall units have glass doors and glass shelves.
The special brackets for h glass shelves do not fit into the holes provided for the normal shelves in the carcase so you have to drill them out by another 2mm.
All was going fine until the drill snagged on the last one and went all the way through, this would be ok, but typically it was on the showing side.
Any thoughts on how to fill, the carcases are light oak style. I have some oak paneling and have considered using that to make a full side panel, but that may be over kill
I have attached a pic
Help please!!!!
I have kitchen units from Wren (yes i know...) two wall units have glass doors and glass shelves.
The special brackets for h glass shelves do not fit into the holes provided for the normal shelves in the carcase so you have to drill them out by another 2mm.
All was going fine until the drill snagged on the last one and went all the way through, this would be ok, but typically it was on the showing side.
Any thoughts on how to fill, the carcases are light oak style. I have some oak paneling and have considered using that to make a full side panel, but that may be over kill
I have attached a pic
Help please!!!!