-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Dripping Tap-stripped grub screw
- Thread starter mjtefc9
- Start date
If you force the spout up a few mm's as though you were removing the spout you might be able to trap the grubscrew to give you a shot at using the key to pull the screw tip out of the tap body. then pull the spout up and out of the mixer bodyto work the grub screw free and check if you've damaged anything.
You will have to re-tap all the threads.
if this abovedoesnt work then remove the mixer from the sinkand work on it more freely.
Drilling out can be tried, jam a "just fit"bit in the grub screw hole and use the drill slowly in reverse.
or same again only in forward while putting slow presure on the drill. but drilling can go way wrong and damage the fittin.
You will have to re-tap all the threads.
if this abovedoesnt work then remove the mixer from the sinkand work on it more freely.
Drilling out can be tried, jam a "just fit"bit in the grub screw hole and use the drill slowly in reverse.
or same again only in forward while putting slow presure on the drill. but drilling can go way wrong and damage the fittin.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Similar threads
