I need some advice guys. I recently moved into a repossessed house and the 'DIY' is pretty shoddy! Bellow are pictures of the half finished bathroom. If you can see in the pictures he didn't quite go to the edges with the drywall.. Would I be better off cutting back a few inches and putting a new bit on to reach the corner or just fill in what's there? Then I can carry on with the corner beading. I'm not sure what's best. I'm new to this DIY thing as you can probably tell.
Also in the first pic in the corner there's a huge gap. Would I be better off ripping it all off or would filler solve this or could I just get away with doing the corner beading as it?
Also on the 2nd picture I understand I need to corner bead along the edge but there doesn't seem to be enough room for metal beading. What would be the best solution for this?
Cheers guys.
Also in the first pic in the corner there's a huge gap. Would I be better off ripping it all off or would filler solve this or could I just get away with doing the corner beading as it?
Also on the 2nd picture I understand I need to corner bead along the edge but there doesn't seem to be enough room for metal beading. What would be the best solution for this?
Cheers guys.