I have extended 2 pir cables by using chock blocks and rewiring sensors as they were previously (six wire). I cannot set the alarm now, All of the zone lights are lit but it just beeps quietl and doesn't go into "set". I did this while the system was still powered up
I have checked the internal fuse which is OK. None of the sensors now "flash" when you move in front of them. I have checked the wiring and am sure that they are wired as before. I am not getting 12V at the sensors either.
I have been told I may have to enter a master reset code, is this the case ?
I have checked the internal fuse which is OK. None of the sensors now "flash" when you move in front of them. I have checked the wiring and am sure that they are wired as before. I am not getting 12V at the sensors either.
I have been told I may have to enter a master reset code, is this the case ?