Euro Mini Alarm

[whit66]

Anyone know why my Euro Mini Alarm control panel has gone blank and all of the PIRs are not working. I have changed the 12v back up battery but nothing has changed.


other post read:
"I recently removed the front cover of a PIR to decorate and as in the past the tamper alarm sounded, but there was no indication on the control box so I could not reset the alarm. after 15 mins the alarm stopped, so I thought it had corrected itself but now none of the PIRs are working. I assumed the back up battery had run flat and as it is 5 years old I replaced it but the system is still not working, any ideas as to what I have done or what I need to do."
Mod

 

[steveo44]

Sound like the mains power has been disconnected and then the standby battery has gone flat.

Think you need to restore the mains power.

 

[sparkymarka]

You have blown the aux fuse 800ma .....
1amp will be ok

 

[whit66]

Thanks for your reply Stevo44, as I am not an electrician (it confuses me!!) not sure how to do that, there is a red flashing light inside the large box and the control panel responds when I press the button "D" and put in "2000" it asks me to wait, then nothing.

 

[whit66]

Thanks Sparky will check tomorrow

 

[sparkymarka]

You said it was blank ! . .?

 

[whit66]

Hello sparky, sorry to confuse things but the panel is blank but I read the installation manual just in case it needed re-programming and there is some life but nothing happens after it says "please wait". None of the PIRs are working, so I think there is a breakdown in the electrics and if I now remove the main cover the "tamper" activity also does not work. Do I need to check all the fuses?

 

[sparkymarka]

I would ....check voltage on the panel with a multimeter at aux 12/0v on the pcb (13.80v dc) and 12/0v on bus line for keypad first ....then check fuses for both depending on reading for both..