Hi, I wonder if anyone can help me. I've had a Hive 2 for a while now, but the person who was to install it (a neighbour) hasn't been able to do it yet so I'm keen to do it myself if I can. I know how to isolate the boiler etc.
Currently, my set-up is:
Boiler = Vaillant ecoTEC plus 837
Controller =Vaillant 360f
I've attached images of the set-up diagrams for the existing controller and the Hive 2, and also the inside of the boiler. Can anyone tell me how to wire this?
I've Googled this and one result said to use the L/N/3/4 points of the boiler, mapping to L/N/1 (common)/3(Heating on) of the Hive 2. There already is a wire in the L/N points though, so do I need some kind of loop?
In the existing set-up, the two wires connected to the controller are the +/1 BUS connectors on the left.
Currently, my set-up is:
Boiler = Vaillant ecoTEC plus 837
Controller =Vaillant 360f
I've attached images of the set-up diagrams for the existing controller and the Hive 2, and also the inside of the boiler. Can anyone tell me how to wire this?
I've Googled this and one result said to use the L/N/3/4 points of the boiler, mapping to L/N/1 (common)/3(Heating on) of the Hive 2. There already is a wire in the L/N points though, so do I need some kind of loop?
In the existing set-up, the two wires connected to the controller are the +/1 BUS connectors on the left.