Fitting a drop-in sink, Clips to hold sink in worktop

[ETAF]

I about to fit a Sink into a worktop in a utility room i'm making
I'm just workign out the position and everything, when i looked at the mounts - I have in the past had small clips that hole the sink in - BUT not on this B&Q sink we purchased back in 2019 when we first planned to do the utility

I have attached some pitcures of how the sink is expected to be fitted to the worktop with the supplied clips - Which is not really going to work -

I have also purchased some clips off amazon, (see image also ) which i thought should work - arriving tomorrow - BUT on reflection I dont think they would work , as the sink would just lift off those - Unless i can fix into the side of the sink somehow

any suggestions ???

I used CT1 for a lot of applications and have used there Bathroom silicon BT1 and also some of there new caulk and been very impressed - I suppose i could use the grab adhisive they have now
C-Tec Power Grab n Bond Construction Adhesive 290ml

C-Tec Power Grab n Bond Construction Adhesive

With its phenomenal grab and rapid curing, PGB Power Grab ‘n’ Bond can reduce labour times by up to 50%. It will adhere to almost any material with no need for any additional fixings – PGB is a game-changer when it comes to heavy-duty versatile bonding.PGB adhesive has an incredible ability to...

www.toolstation.com

 

[Harry Bloomfield]

When I fitted our kitchen sink and utility sink, I found the adhesive/sealer was more than adequate. The clip just pulled the sinks tight down to the sealant, and took up the any slight distortion.

 

[ETAF]

thanks, that probably the way to go - i can put them in round the basin i guess