Hi
I am imagine most Franke Kitchen mixer taps are pretty similar in the information I require, but it a sad time when not even Franke can give you the information I need.
The tap was purchased direct from Amazon, at the time I did not know it was a Polish tap and not a UK model. The enquiry went through the ranks at Franke and not one person could give the information to install this tap. Due to the nature of my pipework I require a pair of tap connectors that are slightly longer than what came with the item. There was no info with the tap, on the tap connectors or on the Franke website as to what thread size i required to fit into the base of the tap (M10/M12). As a last resort I asked the question on Amazon and someone replied saying an M10 thread, I purchased a new pair of connectors and on comparing them to the ones supplied the M10 braided section seems too narrow. The thread ends for both pairs when you eyeball them seem pretty similar and both screw in at slightly different depths but appear secure. I am left baffled and hopefully someone else could shed some light on what thread is best.
Tap purchased: https://www.amazon.co.uk/Franke-15-...d=1468441195&sr=8-9&keywords=franke+tap+mixer
Many thanks in advance
I am imagine most Franke Kitchen mixer taps are pretty similar in the information I require, but it a sad time when not even Franke can give you the information I need.
The tap was purchased direct from Amazon, at the time I did not know it was a Polish tap and not a UK model. The enquiry went through the ranks at Franke and not one person could give the information to install this tap. Due to the nature of my pipework I require a pair of tap connectors that are slightly longer than what came with the item. There was no info with the tap, on the tap connectors or on the Franke website as to what thread size i required to fit into the base of the tap (M10/M12). As a last resort I asked the question on Amazon and someone replied saying an M10 thread, I purchased a new pair of connectors and on comparing them to the ones supplied the M10 braided section seems too narrow. The thread ends for both pairs when you eyeball them seem pretty similar and both screw in at slightly different depths but appear secure. I am left baffled and hopefully someone else could shed some light on what thread is best.
Tap purchased: https://www.amazon.co.uk/Franke-15-...d=1468441195&sr=8-9&keywords=franke+tap+mixer
Many thanks in advance