I am planning to fit a frost and pipe stat to my boiler located in my garage. I am pretty sure I understand the wiring required to fire up the central heating in the event of the frost stat kicking in.
In addition to the boiler the hot water tank and a heat exchanger for a pool are located nearby both on separate zone valves but both on the HW channel of the programmer. Am I correct in thinking that if I wire the output from the pipe stat to the live on all of the zone valves the this will create a link between the CH and HW channels when the programmer is in use.
If this is correct any suggestions on how to overcome this, or do I just need another frost and pipe stat set.
Thanks is advance for any replies
In addition to the boiler the hot water tank and a heat exchanger for a pool are located nearby both on separate zone valves but both on the HW channel of the programmer. Am I correct in thinking that if I wire the output from the pipe stat to the live on all of the zone valves the this will create a link between the CH and HW channels when the programmer is in use.
If this is correct any suggestions on how to overcome this, or do I just need another frost and pipe stat set.
Thanks is advance for any replies
