I've attached a photo of the gap at the end of the floorboards where they meet the patio door, there has been a bit of mould on the walls to each side. I'm thinking maybe just to marine ply the floorboards at that location, in preperation to lay oak boards on top, but wondering if the gap should be filled somehow? Thoughts and advice appreciated.
Gap between patio door and floorboards
- Thread starter wingit
- Start date
- Joined
- 12 Aug 2022
- Messages
- 493
- Reaction score
- 261
- Country
If it was me I would just clean out the gaps and fill them. Good luck with marine ply. Have a read about it. It isn't watgerproof nor is it rot proof only the glue they use is waterproof, if you are lucky. What they sell as marine ply these days is ruubbish and it is called BWP. All the BWP stuff that I have bought for my boat including Buffalo Board has delaminated within six months. I don't think the Buffalo Board lasted that long.
sheetmaterialswholesale.co.uk
Marine Plywood - Low Prices - Sheet Materials Wholesale
What rings into your consciousness when you hear about marine plywood? Water-resistant plywood that can be used in the extremely cold zones? Well, that is, perhaps, the assumption for most people. But is there a fraction of truth in this claim? Well, that is what we seek to answer in this guide.
sheetmaterialswholesale.co.uk
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
