Gaps in run of base cabinets

[jppetanque]

Hi, I'm new to this webpage and after some advice. I'm fitting the kitchen units myself and noticed the wickes designer isnt the most helpful. I have a 25mm gap and a 35mm gap either side of the middle cabinet on the plan. Can I not lose this at the ends as both are corners.... with a bigger corner post or filler? I've attached picture to help with problem. Any help would be great.

 

[chirpychippy]

Can you post a picture of the kitchen plan please?

 

[jppetanque]

Sure, it's the bottom wall where the issue is. Probably easily solved for someone who knows what there doing lol

 

[foxhole]

You could shuffle each corner unit in ,increasing the corner posts dimension to remove the extra,

 

[Harry Bloomfield]

You could shuffle each corner unit in ,increasing the corner posts dimension to remove the extra,

Alternatively, could you arrange them as per the drawing, and fill the gaps up with vertical end panels.

 

[foxhole]

Alternatively, could you arrange them as per the drawing, and fill the gaps up with vertical end panels.

Panel are 18mm , needs 60mm

 

[Notch7]

Hi, I'm new to this webpage and after some advice. I'm fitting the kitchen units myself and noticed the wickes designer isnt the most helpful. I have a 25mm gap and a 35mm gap either side of the middle cabinet on the plan. Can I not lose this at the ends as both are corners.... with a bigger corner post or filler? I've attached picture to help with problem. Any help would be great.

That’s not a gap, they must be allowing for a packer fillet or something

quite often they use end panels to create a dummy face frame look - recently did a Howdens with those

 

[Harry Bloomfield]

Panel are 18mm , needs 60mm

3x18 two on one side one on the other = 54. leaving 6mm. 6mm can easily be lost in the corners.

 

[foxhole]

3x18 two on one side one on the other = 54. leaving 6mm. 6mm can easily be lost in the corners.

Would look cack.

 

[jppetanque]

Thanks foxhole, I thought would be best idea. Just seems odd having different size gaps either side. The corners are magic mesh but have blanking panels but I guess I use a dec base panel to fill the extra gap to corner post?

 

[foxhole]

Hi, I'm new to this webpage and after some advice. I'm fitting the kitchen units myself and noticed the wickes designer isnt the most helpful. I have a 25mm gap and a 35mm gap either side of the middle cabinet on the plan. Can I not lose this at the ends as both are corners.... with a bigger corner post or filler? I've attached picture to help with problem. Any help would be great.

Free shop designers just want to fit as many units as possible into kitchen design , they have little interest in what it will look like.