Hi anyone know if there is a setting to adjust the time that the boiler sits before going to the value of d.0 . Currently the boiler seems to sit for a good few minutes whilst it establishes if it can ramp up. Obviously this causes delays in re-heat times considering it is installed with a fast recovery cylinder quite a percentage of the time is whilst it sits at a relatively low flow temp until ramping up.
Glow worm ultracom 2 sxi time taken to go to full burn mode
- Thread starter scoobydo123
- Start date
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Similar threads
