I take it that Gorilla is a US brand name glue. What we really need to know is what type of glue it is: PVA, superglue, latex, etc.
Whatever it is there may be another way. If the glue spots are small and resting at the top of the pile you can cut them out. I've done this lots of times with tar spots and solder splashes. The slight depression in the pile is barely visible - even if you know where to look.
If the glue spots are small and resting at the top of the pile you can cut them out. I've done this lots of times with tar spots and solder splashes. The slight depression in the pile is barely visible - even if you know where to look.
i've done this with cigarette burns - scrape as much as the cr*p off as possible, then find an area that isn't noticeable and shave off some fibres (just a few from here and there - not down to the pile just so it doesn't look any different from the rest of the carpet) then glue these fibres into the *ahem* shaved hole - i've done this a number of times and if done properly you canna see em like
By the time you read this the glue will have gone off, in its liquid state it can be cleaned with acetone but once dry thats it.
Gorilla glue is a polyurethane glue for those that don't know, it is available in the UK and is one of the best PU glues although it is quite expensive.
As the others have said, cut out what you can once it is dry.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local