This ‘radiator’ has a small pump and electronics with a receiver and circuitry to control the immersion heater. Heated water circulates in the unit
The pcb has an overheat stat but thd massive problem is unit needs stripping down to insert a straight paper clip through a hole in the guts of the control box only when control box is removed from guts of the radiator. BTW, heated water circulates in the radiator to heat it
I changed the pcb from a recovered radiator to get the radiator working. Worked for a year. Now the led shows green or red depending on control knob position like rest of the radiators but no heat.
Do not know John. Will need to check the pcb. There was a pile of these radiators that were removed for disposal. I removed the active parts and disposed the panel radiator. Of the 4 that I recovered, two had tripped to overheat. One in daughter’s place had done the same. Reset the trip and it worked for a year.
The pump is running in in response to the heat demand but immersion heater is not
Be it oil or water filled, not really a storage radiator, although it does store a small amount of heat, but not really expensive, how much time and effort is it really worth to get an old one working?
I have seen some really clever controls, but as to if worth the money is another question.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local