Heatline S30

Bungeeman · 30 Jan 2008

I have a Heatline S30. My problem is that the burner will only come on briefly, then cut out. It will not re-ignite and the warning light comes on for 'gas or flame failure'. Turning off and on again sometimes gets it started but it will still not re-ignite. Is this a pcb problem, and are they easy to replace?

Agile · 30 Jan 2008

It sounds much more likely to be a combustion issue which will need a competent CORGI to investigate.

However, it could be a faulty PCB.

Tony

Bungeeman · 30 Jan 2008

Agile said:
It sounds much more likely to be a combustion issue which will need a competent CORGI to investigate.

However, it could be a faulty PCB.

Tony

THanks for that, Tony. I'll try to get hold of one when I get home.

diynot

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

Heatline S30

Bungeeman

Agile

Bungeeman

DIYnot Local

Similar threads