Help! Concorde c/h boiler -blocked?

Joined
29 Oct 2004
Messages
13
Reaction score
0
Country
United Kingdom
I have 8 rads. and a microbore system.
The blr. is a concorde WRS240A

I changed the kitch rad, and now can't get any hot water from taps!

Info.
It took 3 hrs, to bleed rads, pump on /blr.off! (rads now fine)

The blr. has a separate rad. circuit and h/w circ
The cold make up tank feeds into the h/w circ. (gravity fed)
Question:
Why can I only get any cold water from taps!
Any suggestion please?
 
Sponsored Links
Thanks PVM!

The cylinder is only 600mm above the boiler (in bedroom cupboard) and the cold water fill branches in the hw. circ behind the cylinder.

Any ideas on how I can get rid of an air lock in the h/w circuit?

(There is a drain cock on the biler, but no apparrent bleed valve).
Thanks again!
Magicman
 
Sponsored Links
Alternative would be to "crack" the joint at the HW cylinder to let air out. A wet job usualy!
 
Thanks chrisR

I'll make that plan B!

(seconds thoughts , I might make it plan A- I'm getting to the point where I desparately need a good wash!!!)
M
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top