I am replacing an old shower mixer tap with new. When the old is removed it will leave 1/2 inch threaded ends which will need fixing to 22mm tails on the new. I will be using flexible pipe/hose whatever to make this connection. What do I ask for.......................!!
Help for beginner with pipe sizes
- Thread starter robin45
- Start date
Sponsored Links
Cut the pipe back, which is presumably 15mm?
, then use something like this which is pushfit:
http://www.screwfix.com/app/sfd/cat/pro.jsp?cId=101316&ts=52002&id=28075
Or use one of these which has a 15mm compression end. If you remove the compression nut the thread will be 1/2" bsp parallel male, which will go in your present fitting if you use lots of ptfe tape.
, then use something like this which is pushfit:
http://www.screwfix.com/app/sfd/cat/pro.jsp?cId=101316&ts=52002&id=28075
Or use one of these which has a 15mm compression end. If you remove the compression nut the thread will be 1/2" bsp parallel male, which will go in your present fitting if you use lots of ptfe tape.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
