Hive Heating Only - Wiring

[sanger]

Just purchased the above, wanted to clarify the wiring for a glow-Worm Ultimate 3.

Mains I can daisy from the incoming on the boilers supply, but can I use the 24v link on the bottom right for switching?

0 on boiler to common on Hive, then use RT24 to either NO/NC on Hive?

 

[stem]

Provided that with your particular boiler you don't have to open up a room sealed part of it to access the wiring terminals, then you can connect the Hive Common (1) and heating on 'NO' (3) to the RT24 terminals. Remove any wire link between the two terminals if fitted. [You won't need to use the NC terminal]

However, if it is necessary to open up a room sealed compartment to access the wiring terminals, then it's not a DIY job and should be done by a Gas safe RGI who can carry out the necessary safety checks to make sure it is properly sealed up again afterwards.

 

[sanger]

Thanks for your help, now working!