Hive Wiring. Replace Climote with Hive system.

[wizarddolan]

Hi, I am replacing my Climote controller with Hive.. Attached is current set up for Climate but I am having difficulty with my wiring transfer. Appreciate any advice. I have bought a dual and singular controller and have power into both. Thank you

 

[RandomGrinch]

On your existing controller, It appears as if all the grey wires - connected to common terminals 1, 2 and 5 - all join together into the L terminal.
Can you confirm this is the case?

An does your controller provide any cooling functions?

You may also wish to change your username, to avoid being flooded with spam!

 

[wizarddolan]

Thanks. Request sent.

Yes, Comm1, 2 and 5 are wired back to L.

I have 2 heating zones and hot water zone only. No cooling.

 

[RandomGrinch]

Then, assuming as you say, both Hives have power and the single channel Hive will go with the bedroom zone...

For the Single Channel Hive:
Add a short link wire between L and terminal 1 (Common)
Move brown wire in Climote terminal 6 (Bed NO) to Hive terminal 3 (Heating ON (NO))

For the Dual Channel Hive:
Move brown wire in Climote terminal 3 (Living N/O) to Hive terminal 4 (Heating On (NO))
Climote terminal 4 (Water N/O) to Hive terminal 3 (Hot Water On (NO))
Climote terminal 7 (Water N/C) to Hive terminal 1 (Hot Water Off (NC))
No extra link wires are required.

 

[wizarddolan]

Thank you so much. Everything works as it should.

Really appreciate your help.

 

[RandomGrinch]

Thank you so much. Everything works as it should.

Really appreciate your help.

Brilliant! - well done for sorting that out and thanks for letting us know the outcome