I've just installed a Honeywell Galaxy G2-20 along with the RF portal (no wireless sensors) and have two TCC8M key fobs. The system is fully working except I'm unable to set or unset the alarm using the key fobs.
The system is configured as follows: -
RF Portal address 5
Keypad address 0
Two users have been assigned RF fobs (learned on to the system)
50=RF Options - 1=RF Fob unset
On the RF Portal the red BUS LED indicates 'Good communication'
When I press any of the buttons on the fobs the RF Portal RX LED flashes but not the TX LED
On the fobs, pressing any button, the associated LED flashes rapidly for about 4 seconds.
Is the RF portal faulty or have I missed setting a parameter?
The system is configured as follows: -
RF Portal address 5
Keypad address 0
Two users have been assigned RF fobs (learned on to the system)
50=RF Options - 1=RF Fob unset
On the RF Portal the red BUS LED indicates 'Good communication'
When I press any of the buttons on the fobs the RF Portal RX LED flashes but not the TX LED
On the fobs, pressing any button, the associated LED flashes rapidly for about 4 seconds.
Is the RF portal faulty or have I missed setting a parameter?